SwitchBackup

Cisco Write Erase. How to Create & Erase Startup Configuration File of CISCO Switch YouTube Device# factory-reset all No system configuration is required to use the factory reset command but the command won't work in stacking mode Factory reset: You can reset a Cisco router or switch to its factory default configuration by using the "write erase" command followed by the "reload" command

The write erase command erases the entire startup configuration, except for the following: To remove the boot variable definitions and the IPv4/IPv6 configuration on the mgmt0 interface, use the write erase boot command. To reset 6500/6000 switches which run Cisco IOS Software in redundant mode to factory defaults, you need to complete these steps: Erase the startup configuration with the erase startup-config command on the active Supervisor Engine

Process of Backing Up and Restoring the Cisco IOS

If write erase command is going to delete the NVRAM, Why do I need to delete vlan.dat file manually?? Hi gentlemen, What's the different between "write erase" & "erase startup-config" comands? With which command I can erase all of my configurations? Thanks Also, using the "ALL" will erase all the content from the NVRAM, all the Cisco IOS images, including the current boot image, boot variables, startup and running configuration data, and user data.

Erase_startup_configuration , cisco , ccna , yaser.rahmati , . If write erase command is going to delete the NVRAM, Why do I need to delete vlan.dat file manually?? The write erase command erases the entire startup configuration, except for the following: To remove the boot variable definitions and the IPv4/IPv6 configuration on the mgmt0 interface, use the write erase boot command.

How To Save Configuration in Cisco Router And Erase Cisco Router. To reset 6500/6000 switches which run Cisco IOS Software in redundant mode to factory defaults, you need to complete these steps: Erase the startup configuration with the erase startup-config command on the active Supervisor Engine However, the "new" way of doing it is erase startup-config or even erase nvram:, if you want to remove everything from the routers non-volatile memory (it more or less does a format of the NVRAM: file system).